In order to get access to the Laser Lab in the Kuggen Studio, all IxD students need to attend a mandatory workshop in operations and safety for the Laser Lab.

Please sign up for a workshop by using the following links. YOU ONLY NEED ONE workshop, so sign up with Thommy Eriksson or Arturs Umbrasko. Please note the date and time, and show up in good time at the start of the workshop. We’ll meet in room Low in the Studio (Kuggen, Lindholmen).

We will arrange test files for you to cut (.svg file format).
Before the workshop, YOU HAVE TO WATCH the introduction videos further down this page.
During the workshop, everyone will make a simple cut and print, yourself, under guidance.
The workshop will take about 30 minutes.

After the workshop, you will get access to the Laser Lab with your access swipe card.

Workshop booking

You book a workshop slots here:

https://choodle.portal.chalmers.se/fJW16JxrKlrk3d9r

The file we will use

This is just if you are curious, you don't need to bring this to the workshop.

.svg file for laser cutting

s/0q5teiugfw5x0r8b2e5p0u5faw757zbx

Introduction videos

You have to watch these before the workshop.

The Laser Cutter